So I am working on a project where I want a big dumb red button. I got a light-duty industrial illuminated pushbutton from AliExpress (this one, if you want to know: 22mm 3v-6v, non-locking). It looks like it will be fine to use, but I’m confused about the LED. It seems to work regardless of which orientation, and I briefly tried it without a resistor, and that was fine too.
I’d like it to be fairly bright, but as someone who has blown up his share of through-hole diodes in his day, I would rather not mess up this one, since without the diode light it’s sad and dumb, rather than glorious and dumb. :-)
My question is this: is there any standard for these illuminated switches that would make it likely that there is some resistor and diode stuff going on inside the housing, such that this thing is fine to just wire up and use?
You must log in or register to comment.
bigclivedotcom has a few button videos covering elevator and industrial illuminated buttons. I don’t think he’s done exactly the same as this, but I think no real standard, but they may be cloned off a brand.
Interesting videos to see what’s inside the different types. Some use a dual chip back to back parallell led - so that it can light on each half wave of a.c. - or if d.c that’d be either polarity. some have resistors, some have resistors and capacitive dropper (mains rated)
I’d guess the reason for the voltage range is the different resistance included. I don’t think you’ll really know unless you either measure the current draw, or open it up.